A couple weeks ago we shared How to Make Bias Tape. Now let us make piping. It’s actually quite simple. And every thing could use a little piping right? Just don’t sew through your finger.
Making piping is a two-step process: Cutting bias strips, then sewing them around cord. I’ll show you How to Make Piping after the jump…
How to Make Piping
First we cut bias strips, then we sew the piping. For this homemade piping I used Valori Wells Del Hi Floral Home Decor weight (but you can use regular cotton).
CUTTING BIAS STRIPS
I showed you my trick for cutting bias strips quickly and simply in the How To Make Bias Tape post, but I’ll run through it one more time here. Just so you know, I actually cut these to make some double welt cord (I’ll show you how later) so I cut them pretty wide and I need a lot so I started with a whole yard of home decor fabric, which is 54″ wide. You probably don’t need this much:
1. Fold one edge into a right triangle:
2. Cut that triangle off and flip it over, aligning the straight edge right sides facing with the straight edge of the opposite side. Sew that in place:
3. Open up the fabric so it’s a parallelogram and draw lines on the bias parallel to the triangle edges equal distances apart. To determine the width, you just need to be able to wrap it once around your cord and have about a 5/8″ seam allowance left over, so usually 1.5″ will do it. It really doesn’t need to be very specific:
4. Bring the long sides together and offset the first drawn row so the end of it lines up with the start of the second row. The fabric will spiral to do this so it will seem very twisty and strange, but it’s working. Sew together right sides facing with a 1/4″ seam allowance:
5. If you can do it, iron your seams open now (with a whole yard of fabric this is easier, if you started with a 1/2 yard or less you might want to wait until after you cut your strips to iron the seams open):
6. Start cutting on one side, cut along your lines in the spiral shape like so:
Keep cutting until you have one long strip:
If you haven’t done it already, iron your seams open now.
1. First you’ll need some cord. You can get this at any sewing shop in a bunch of different sizes and from a bunch of different materials. I have no preference, it just depends on your project. Get more length than you think you need, just in case:
2. Lay the cord in the center of the wrong side of your bias strip:
3. Fold the bias strip over the cord. You don’t have to pin in place but if it’s your first time go ahead and pin it will make your life easier:
4. If you have a piping foot you are fancy, go ahead and use it. If not, use your zipper foot to sew a basting stitch (a straight stitch set to the longest stitch width, usually a 5) right up against the edge of the piping:
Look at that! Also, if you hate sewing you can skip sewing and use fusible tape to attach the two sides, but I figure if you are making piping you are probably planning to sew with it, and I think the sewing is quicker/easier than the ironing.
Now you probably don’t want such a big seam allowance making your projects all bulky, so trim the raw edges down to the appropriate size. If you are making piping just to stock up on it and don’t have a particular project in mind, cut it to 5/8″.
Wrap it around a piece of cardboard until you need it. Pat self on back. Done!
P.S. If you are a looking for a way to store your extra bias strips, a toilet paper roll works well. I REALLY wanted to do a post on “designer fabric toilet paper” and post a picture of this by the loo, but I chickened out:
So, pretty simple right? Think you’ll give it a try?